@echo off
:: call for build script
call ".\make&build.bat" %*

if NOT %errorlevel% == 0 (
exit
)

@echo ================================[ StLink ]================================
.\Tools\xpack-openocd-0.12.0-7\bin\openocd      ^
-f .\Tools\Specific_Config\stlink-interface.cfg ^
-f .\Tools\Specific_Config\stm32g0x-target.cfg  ^
-c "program Build/Debug/STM32G030F6P6_Evaluation.elf verify reset exit"

if %errorlevel% == 0 goto end

@echo ================================[ CMSIS-DAP ]================================
.\Tools\xpack-openocd-0.12.0-7\bin\openocd         ^
-f .\Tools\Specific_Config\cmsis-dap-interface.cfg ^
-f .\Tools\Specific_Config\stm32g0x-target.cfg     ^
-c "program Build/Debug/STM32G030F6P6_Evaluation.elf verify reset exit"

if %errorlevel% == 0 goto end

@echo ================================[ STM32CubeProgrammer-Usart ]================================
:: STM32G0x flash sector size：2K
:: Uart mode can't erase flash memory over internal NVM size (32K). 
:: Target flash MUST be erased first (try flash related functions or using debugger), otherwise the data can't be witten.
:: Commands below erase all legal sectors manually and skip address check for allowing write data to extra hidden flash.
STM32_Programmer_CLI.exe -c port=COM6 fc=hardware rts=high dtr=low -e [0 15] --skipErase -d .\Build\Release\STM32G030F6P6_Evaluation.elf
STM32_Programmer_CLI.exe -c port=COM6 fc=hardware rts=low dtr=high -e [0 15] --skipErase -d .\Build\Release\STM32G030F6P6_Evaluation.elf

if %errorlevel% == 0 (
@echo ***** Need To Reset Target Manually *****
goto end
)

@echo ================================[ Program Flash Failed ]================================

exit

:end
@echo ================================[ Program Flash Accomplished ]================================