Import xPack OpenOCD 0.12.0-7 and GNU Make 4.4.1 from x86_64-w64-mingw32.

2026-09-14 16:20:05 +08:00
parent 2b73c30a9d
commit 534c017e0f
1133 changed files with 74341 additions and 0 deletions
@@ -0,0 +1,42 @@
+# SPDX-License-Identifier: GPL-2.0-or-later
+
+Prerequisites:
+The users of OpenOCD as well as computer programs interacting with OpenOCD are expecting that certain commands
+do the same thing across all the targets.
+
+Rules to follow when writing scripts:
+
+1. The configuration script should be defined such as , for example, the following sequences are working:
+	reset
+	flash info <bank>
+and
+	reset
+	flash erase_address <start> <len>
+and
+	reset init
+	load
+
+In most cases this can be accomplished by specifying the default startup mode as reset_init (target command
+in the configuration file).
+
+2. If the target is correctly configured, flash must be writable without any other helper commands. It is
+assumed that all write-protect mechanisms should be disabled.
+
+3. The configuration scripts should be defined such as the binary that was written to flash verifies
+(turn off remapping, checksums, etc...)
+
+flash write_image [file] <parameters>
+verify_image [file] <parameters>
+
+4. adapter speed sets the maximum speed (or alternatively RCLK). If invoked
+multiple times only the last setting is used.
+
+interface/xxx.cfg files are always executed *before* target/xxx.cfg
+files, so any adapter speed in interface/xxx.cfg will be overridden by
+target/xxx.cfg. adapter speed in interface/xxx.cfg would then, effectively,
+set the default JTAG speed.
+
+Note that a target/xxx.cfg file can invoke another target/yyy.cfg file,
+so one can create target subtype configurations where e.g. only
+amount of DRAM, oscillator speeds differ and having a single
+config file for the default/common settings.